Program a wall remote for a B&D sectional opener

Check your model

Applies to Secure SDO-6V3, Smart SDO-7V3 and Smart Pro SDO-9V3. Check the model/version label and match the controls to the linked manual before starting. A familiar product name or remote appearance alone does not establish compatibility.

This procedure does not cover every older B&D opener, PanelMax, commercial operator or gate motor. Use the instructions for that exact model. Roll-A-Door Secure and installations with an automatic lock also need their separate lock/system procedure.

Before you start

Work only on a sound door with its travel path clear and in view. Use safe access to the owner controls; if you cannot reach them safely, ask an installer for help. Remove only the small controls cover shown in the manual, not the motor housing. Keep children away and be ready for door movement when a remote is pressed.

Program normal Open / Stop / Close

1. Switch on the opener’s power and remove the controls cover.
2. Press MODE repeatedly until the remote indicator is lit.
3. Press and keep holding the blue CLOSE / down-arrow button on the opener.
4. While holding CLOSE, press the chosen button on the wall transmitter for 3 seconds, then release the transmitter button.
5. Press that same transmitter button again for 3 seconds, then release it. Release the opener’s CLOSE button.
6. Refit the controls cover. Stand clear with the door in view and press the programmed button to test operation.

Position your wireless wall transmitter in view of the door, away from children and at least 1.5 metres above the floor. Use these steps to code a compatible wireless transmitter. A wired wall switch needs its own installation instructions. Ask an installer to mount it if you cannot do so safely.

Read the coding feedback

These models store up to 64 transmitters. Check the coding feedback before repeating the steps, as coding an existing control can remove its assignment. Use this table while programming; the main-light warnings after a door cycle have different meanings.

If the control does not work

• Check the transmitter is compatible and its battery is serviceable.
• Confirm the remote indicator was selected, rather than network or adjustment mode.
• Confirm you held the opener’s CLOSE button during both three-second transmitter presses.
• Check the signal table before trying again; do not erase every remote just to add one.

If the controls, indicators or release mechanism differ from this guide, stop and find your model’s manual or call us on 13 62 63. Have the opener model/version, remote or accessory model and the symptom ready. For damage or repeated faults, arrange a repair.

Your manuals and helpful downloads

• SDO-6V3 / 7V3 / 9V3 manual, section 15.1, page 16
• Wall transmitter, section 15.5, page 17
• Matching Quick Operation Guide, section 3
• More from B&D

Keep the guide for the model and equipment fitted to your garage. The documents below include the diagrams, full warnings and installer information to support the steps above.